Install Driftwood Kit 1800Dwk - Valor 1800JN Installation & Owner's Manual

Install Driftwood Kit 1800DWK

Material required
• Driftwood Kit, which contains:
◊ Left and right steel platforms
◊ 7 logs
◊ 10 pebbles
◊ 1 bag of vermiculite
• Small container to distribute vermiculite (not
supplied)
Installation
Platform
Carefully unpack the kit.
1. Install the steel left and right platforms around the
burner as indicated. The openings in the platforms
should be underneath.
Installed platforms
2. Fill a small container with approximately 3 cups
(750 ml) of vermiculite from the bag supplied.
3. Carefully spread the vermiculite on the surface of
burner patting it gently with your hand to form a
single layer to the approximate level of the top of
the fl ange at the edge of the burner. Do not pour too
much to avoid blocking the burner ports.
Installation
NOTE: Ensure the area within the pilot shield is
clear of vermiculite.
Logs and rocks
The log have pegs or notch to help you locate them on
the platform. Install the logs as shown below.
1. Place the left hand rear log on the left hand side of
the burner fi tting the log's pegs into the holes of the
platform as indicated.
2. Place the left hand cross log resting it into the
recess on top of the rear log as indicated.
QUALIFIED
INSTALLER
Pilot shield
recess on top of rear log recess on top of rear log
43