Insert Modeling Base - µ-Dimension SST 1200es User Manual

If the printer was off and is at room temperature, it requires
approximately 40 minutes to warm up before you can perform
any functions. Temperatures are factory-preset and not
adjustable. The panel displays the head and envelope
temperatures while Dimension is warming up and cooling down.
For safety, the head and Z Platform do not move while the
chamber door is open. During warm-up and operation the door is
locked. The door can be opened only when Dimension is not
building a part, getting ready to build a part, or in Pause mode.

Insert Modeling Base

Make sure retainers are turned 'down' - so as not to interfere with
the modeling base installation. Set the modeling base on the Z
Platform aligning the tabs on the modeling base with the slots on
the metal tray. Slide the modeling base toward the back of the unit
until its front edge (with the handle) is flush with the front edge of
the tray (see Figure
turning them up.
When inserting and removing the modeling base, use the handle
to avoid touching the top surface. Grease and oil that contact the
top build surface could cause poor part adhesion. You can clean
the build surface with isopropyl alcohol if necessary.
NOTE
NOTE
7). Secure the base with the two retainers by
NOTE
Figure 7: Inserting a modeling base
Dimension BST 1200es / SST 1200es User Guide
Setup 21
Slide modeling
base into the side
tray guides.
Retainer (1 of 2).