Firmware Upgrade Recovery; Adapter Cable Firmware Upgrade Recovery - Altusen KVM OVER THE NET KN2116A User Manual
Ebterprise kvm solution by aten
Hide thumbs
Also See for KVM OVER THE NET KN2116A:
- Quick start manual (2 pages) ,
- User manual (310 pages) ,
- User manual (251 pages)
Table of Contents
Advertisement
KVM Over the NET™ User Manual
Firmware Upgrade Recovery
Should the switch's main firmware upgrade procedure fail, and the switch
becomes unusable, the following firmware upgrade recovery procedure will
resolve the problem:
1. Power off the switch.
2. Press and hold the Reset Switch in (see Reset Switch, page 11 for details).
3. While holding the Reset Switch in, power the switch back on.
This causes the switch to use the original factory installed main firmware
version. Once the switch is operational, you can try upgrading the main
firmware again.
Adapter Cable Firmware Upgrade Recovery
Should the adapter firmware upgrade procedure fail for one of the KVM
Adapter Cables and the adapter becomes unusable, the following adapter
firmware upgrade recovery procedure will resolve the problem:
1. Unplug the Adapter from the server it is connected to.
2. Slide its Firmware Upgrade Recovery Switch (located next to the Cat 5e
connector) to the RECOVER position.
3. Plug the Adapter back into the server.
4. Repeat the Adapter upgrade procedure.
5. After the Adapter has been successfully upgraded, unplug the Adapter
from the server it is connected to; slide the Firmware Upgrade Recovery
Switch back to the NORMAL position; and plug the Adapter back in.
150
Advertisement
Table of Contents
Need help?
Do you have a question about the KVM OVER THE NET KN2116A and is the answer not in the manual?