Ldap / Ldaps Authentication And Authorization Settings; Cc Management Settings - Altusen KVM OVER THE NET KN2116A User Manual

KVM Over the NET™ User Manual

LDAP / LDAPS Authentication and Authorization Settings

To allow authentication and authorization for the KVM Over the NET
via LDAP / LDAPS, refer to the information in the table, below:
Item
Enable
Type
LDAP Server IP and
Port
Admin DN
Admin Name
Password
Search DN
Timeout
Note: If LDAP Settings is enabled, the LDAP schema for MS Active
Directory must be extended. See LDAP Server Configuration,
page 173, for details.

CC Management Settings

To allow authorization for the KVM Over the NET
(Control Center) server, check Enable and fill in the CC Server's IP address
and the port that it listens on in the appropriate fields.
132
Put a check in the Enable checkbox to allow LDAP / LDAPS
authentication and authorization.
Click a radio button to specify whether to use LDAP or LDAPS.
Fill in the IP address and port number for the LDAP or LDAPS
server. For LDAP, the default port number is 389; for LDAPS,
the default port number is 636.
Consult the LDAP / LDAPS administrator to ascertain the
appropriate entry for this field. For example, the entry might
look like this:
ou=kn4132,dc=aten,dc=com
Key in the LDAP administrator's username.
Key in the LDAP administrator's password.
Set the distinguished name of the search base. This is the
domain name where the search starts for user names.
Set the time in seconds that the
switch waits for an LDAP or LDAPS server reply before it times
out.
Action
KVM Over the NET
switch through a CC
TM
switch
TM
TM