Cornering Lamps; Hazard Warning Lamps; Headlamp Cleaning System - Mercedes-Benz Sprinter Operating Instructions Manual

Hide thumbs Also See for Sprinter:
Table of Contents

Advertisement

Cornering lamps

The cornering lamps improve the illumination
of the road over a wide angle in the direction
you are turning, enabling better visibility in
tight bends, for example.
The cornering light function switches on
automatically, if:
you are traveling at a speed of less than
R
25 mph (40 km/h) and you switch on a turn
signal or turn the steering wheel.
you are traveling at a speeds of between
R
25 mph (40 km/h) and 43 mph (70 km/h)
and turn the steering wheel.
The cornering lamp may remain lit for a short
time, but is automatically switched off after
no more than 3 minutes.
If reverse gear is engaged the lamp on the
i
opposite side of the vehicle switches on
instead.

Hazard warning lamps

G
WARNING
The rear exterior light will be covered if you:
open the rear doors by 90°
R
open the rear dropside.
R
The vehicle will then be difficult for other road
users to see or will not be seen by them at all,
particularly if it is dark or visibility is poor.
There is a risk of an accident.
You should therefore ensure in this and simi-
lar situations that the vehicle is visible from
the rear in accordance with the relevant
national regulations, by using the warning tri-
angle, for instance.
Exterior lighting
Hazard warning lamp switch
To switch on/off: press the £ hazard
X
warning lamp switch.
If you have indicated a turn while the hazard
warning lamps are switched on, only the turn
signal lamps on the side of the vehicle selec-
ted will light up.
The hazard warning lamps switch on auto-
matically if:
an air bag is deployed.
R
you brake sharply and bring the vehicle to a
R
halt from a speed of more than 45 mph
(70 km/h).
If the hazard warning lamps have been
switched on automatically, press the £
hazard warning lamp switch to switch them
off.
The hazard warning lamps work even
i
when the ignition is switched off.

Headlamp cleaning system

The headlamps are cleaned automatically
with a high-pressure water jet if the "Wipe
with washer fluid" function is activated
(
page 107) while the low-beam headlamps
Y
are on and the engine is running.
You can find information on refilling washer
fluid in the "Maintenance and care" section
(
page 258).
Y
95
Z

Advertisement

Table of Contents
loading

Table of Contents