Standard Display; Menus In The On-Board Computer; Activating/Deactivating Highbeam Assist; Switching The Daytime Running Lamps On/Off - Mercedes-Benz Sprinter Operating Instructions Manual

On-board computer (vehicles without steering wheel buttons)

Standard display

Odometer
:
Trip odometer
;
Clock
=
Outside temperature or digital speedom-
?
eter
Fuel gage ( page 185)
Y
A
Selector lever position or current shift
B
range with automatic transmission
( page 142)
Y
To call up the standard display: turn the
X
key to position 2 in the ignition lock.
Press the 4 menu button for longer than
X
1 second.
The information shown in the display
changes from the outside temperature to
the digital speedometer.

Menus in the on-board computer

Overview
If you wish to exit a menu and go to the stand-
ard display:
Press the 4 menu button for longer than
X
1 second.
or
Do not press any button for 10 seconds.
X
The display accepts the changed settings.
Using the f, g, 4 or 9 adjustment but-
tons, you can select the following functions:
Calling up the service due date
R
( page 261)
Y
Checking the oil level (
R
Checking the DEF supply (
R
Preselecting/setting the auxiliary heating
R
switch-on time ( page 124)
Y
R
R
R
R
Setting the time
X
X
X
X
X
i
Activating/deactivating Highbeam
Assist
X
X
X
Switching the daytime running lamps
on/off
If you switch the daytime running lamps on,
the daytime running lamps will automatically
light up when the engine is running.
For safety reasons, it is only possible to
change this setting when the vehicle is sta-
tionary. The factory setting is
in which daytime running lamp mode or day-
time running lamps are mandatory.
page 254)
Y
page 186)
Y
Tire pressure monitor (
Y
Setting the time ( page 187)
Y

Activating/deactivating Highbeam Assist

( page 196)
Y
Setting the daytime running lamps
( page 92)
Y
Turn the key to position 2 in the ignition
lock.
Press the 4 menu button repeatedly until
the hours figure flashes.
Press the f or g button to set the hour.
Press the 9 reset button.
The minute display flashes.
Press the f or g button to set the minute.
If you keep the f or g button pressed,
the value will change continuously.
Turn the key to position 2 in the ignition
lock.
Press the 4 menu button repeatedly until
the _ indicator lamp flashes and the
OFF
or message appears in the display.
Use the f or g button to switch High-
beam Assist on/off.
187
page 295)
on
on
in countries
Z