Operation With The Timer; Timer Overview - Mercedes-Benz Sprinter Operating Instructions Manual

The remote control is in synchronizing
mode.
If you press the Ü button again on the
i
remote control after starting synchroniza-
tion, you will only synchronize this remote
control unit with the receiver. Any other
remote control units that were synchron-
ized will be cleared. Indicator lamp :
flashes alternately red and green (very
slowly).
Press the b button on the remote con-
X
trol.
During data transmission, indicator
lamp : lights up red.
When remote control indicator lamp :
emits two long green flashes, the selected
operating time is synchronized. The indica-
tor lamp in the y auxiliary heating but-
ton goes out.

Operation with the timer

Important safety notes
This is only for vehicles with a hot-water aux-
iliary heater.
G
DANGER
If a switch-on time has been selected, the
auxiliary heating switches on automatically.
If the ventilation is insufficient, poisonous
R
exhaust gases can collect, in particular car-
bon monoxide. This is the case in enclosed
spaces, for example. There is a risk of fatal
injuries.
If highly flammable substances or flamma-
R
ble materials are nearby, there is a risk of a
risk of fire and explosion.
Always deactivate the preselected switch-on
times if you stop the vehicle in such or similar
situations.
Use the timer to:
activate and deactivate immediate heating
R
mode
set up to three switch-on times
R
Operating the auxiliary heating system
set the operating duration to between 10
R
and 120 minutes or to continuous opera-
tion
set the heating level (preselected temper-
R
ature) to a range between 10 and 30

Timer overview

Timer above the overhead control panel
Program column
:
G Sets preselection memory 1 – 3
( page 129)
Y
Sets weekday (Mon. – Sun.)
( page 128)
Y
Menu bar
;
y Switches immediate heating mode
on/off ( page 128)
Y
B Sets the program times
( page 129)
Y
Ñ Sets the day, time and the operating
duration (
Y
ß Sets the heating level
( page 129)
Y
Display panel for: time, heating level
=
and operating duration
à Continuous operation mode active
ß Heating level set
Selects options in program column : or
?
menu bar ; (forwards)
Increases values
Confirms a selection or setting
A
Status bar
B
y Heating mode activated
Activates the timer
C
Cancels or ends settings in a menu
page 128)
127
Z