Mercedes-Benz Sprinter Operating Instructions Manual page 320

Spare wheel
318
Installing
Carefully place the spare wheel onto spare
X
wheel bracket A.
The spare wheel is heavy. When you place
the spare wheel onto spare wheel bracket
A, the center of gravity changes due to the
weight of the wheel. The spare wheel may
slip down or tip over.
Slide the pump lever for the jack into
X
sleeve ? on spare wheel bracket A.
Raise spare wheel bracket A with the
X
pump lever and attach right-hand retaining
hook =.
Slightly raise spare wheel bracket A and
X
attach left-hand retaining hook =.
Pull the pump lever out of sleeve ?.
X
Using the lug wrench, tighten the retaining
X
hook bolts by turning them clockwise.
Replace and engage covers :.
X
Close the rear doors.
X
Cab Chassis version
Removing
Loosen fender nuts = manually and then
X
remove them.
Loosen nuts ; as far as the thread end.
X
Slightly raise spare wheel bracket ? and
X
unhook left-hand retaining hook :.
Assemble the pump lever for the jack and
X
slide it into the sleeve on the right-hand
side of spare wheel bracket ?.
Raise spare wheel bracket ? with the
X
pump lever and unhook right-hand retain-
ing hook :.
Slowly lower spare wheel bracket ? down
X
to the ground.
Lift spare wheel bracket ? slightly and pull
X
the pump lever out of the sleeve.
Use the pump lever to lift the spare wheel
X
beyond the rear edge of spare wheel
bracket ?.
Carefully remove the spare wheel from the
X
bracket.
The spare wheel is heavy. When the spare
wheel is removed, the center of gravity
changes due to the heavy weight of the
wheel. The spare wheel may slip down or tip
over.
Installing
Carefully place the spare wheel onto spare
X
wheel bracket ?.
The spare wheel is heavy. When you place
the spare wheel onto spare wheel
bracket ?, the center of gravity changes
due to the weight of the wheel. The spare
wheel may slip down or tip over.
Raise spare wheel bracket ? with the
X
pump lever and attach right-hand retaining
hook :.
Slightly raise spare wheel bracket ? and
X
attach left-hand retaining hook :.
Pull the pump lever out.
X
Tighten nuts ;.
X
Put fender nuts = in place and tighten
X
them.