Armrests; Seat Heating - Mercedes-Benz Sprinter Operating Instructions Manual

Armrests

To set the armrest angle: fold the armrest
X
upwards by more than 45° ;.
The armrest is released.
Fold armrest = forwards to the stop.
X
Slowly fold the armrest upwards to the
X
desired position.
To fold the armrest up: if necessary, fold
X
the armrest upwards : by more than 90°.

Seat heating

G
WARNING
Repeatedly switching on the seat heating can
cause the seat cushion and backrest pads to
become very hot. The health of persons with
limited temperature sensitivity or a limited
ability to react to excessively high tempera-
tures may be affected or they may even suffer
burn-like injuries. There is a risk of injury.
Therefore, do not switch the seat heating on
repeatedly.
! When you leave your seat, do not place
anything on the seat and switch off the seat
heating. Do not switch the seat heating on
when the seat is not occupied, e.g. when
driving without a front passenger. The seat
heating may otherwise overheat, causing
damage to the seat.
The three red indicator lamps in the c
button show the activated heating level 1 to
3.
The system automatically switches down
from level 3 to level 2 after approximately
five minutes.
The system automatically switches down
from level 2 to level 1 after approximately
ten minutes.
At level 1, the seat heating remains in con-
tinuous operation.
Make sure that the key is in position 1 or 2
X
in the ignition lock.
To switch on: press the c button
X
repeatedly until the desired heating level
has been set.
To switch off: press the c button
X
repeatedly until all indicator lamps go out.
If the indicator lamps of the current heating
level in the c button flash, the seat heat-
ing has switched off automatically. In this
case, too many electrical consumers are
switched on or the battery charge is not suf-
ficient. The seat heating will automatically
switch back to the current heating level when
enough on-board voltage is available again.
Seats
87
Z