Additional lamps
Additional turn signal lamp on the roof
Type of lamp: P 21 W
Switch off the lighting system.
X
Undo screws : and remove lamp lens ;.
X
Applying light pressure to the bulb, turn it
X
counter-clockwise and remove it from the
bulb holder.
Press the new bulb into the bulb holder and
X
screw it in clockwise.
Position lamp lens ; and tighten
X
screws : again.
Perimeter lamp (Cab Chassis)
Type of lamp: W 5 W
Switch off the lighting system.
X
Undo screws : and remove the lamp unit.
X
Changing bulbs
Turn bulb holder ; and remove it.
X
Remove the bulb from bulb holder ;.
X
Press the new bulb into bulb holder ;.
X
Screw bulb holder ; into the lamp unit.
X
Carefully position the lamp housing and
X
tighten screws :.
Courtesy lights, rear compartment
Bulb type: W5W
Press in the latching spring of courtesy
X
light : with a suitable implement, e.g. a
screwdriver.
Pry off courtesy light :.
X
Disconnect cable connector =.
X
Unscrew bulb holder ;.
X
Remove the bulb from bulb holder ;.
X
Press the new bulb into bulb holder ;.
X
Screw bulb holder ; into courtesy
X
light :.
Connect cable connector =.
X
The connector locking spring must engage.
Align courtesy light : on the side and
X
engage.
Interior lighting
General notes
! Have the bulbs in the overhead control
panel replaced at a qualified specialist
workshop. You could otherwise damage
the overhead control panel.
105
Z
Need help?
Do you have a question about the Sprinter and is the answer not in the manual?