Head Restraints - Mercedes-Benz Sprinter Operating Instructions Manual

Seats
86
Do not exceed the maximum permissible
i
number of seats for models registered as
passenger vehicles.
To install the rear bench seat: observe
X
the prescribed installation position of the
bench seat.
Install the two-seat bench seat only on the
driver's side.
Check mounting shells ; on the vehicle
X
floor.
Position the bench seat in the direction of
X
travel in corresponding mounting shells ;.
Slide the bench seat forwards until you
X
hear the locking mechanisms engage.
Check levers : on the anchorages of the
X
bench seat.
All levers : must be flush to the vehicle
floor.

Head restraints

G
WARNING
If head restraints are not installed and adjus-
ted correctly, they cannot provide protection
as intended. There is an increased risk of
injury in the head and neck area, e.g. in the
event of an accident or when braking.
Always drive with the head restraints instal-
led. Before driving off, make sure for every
vehicle occupant that the center of the head
restraint supports the back of the head at
about eye level.
Do not change over the head restraints for the
front and rear seats. Otherwise, it will not be
possible to correctly adjust the height and
angle of the head restraints.
Adjust the head restraint so that it is as close
as possible to your head.
Head restraint (example: luxury head restraint on
the front-passenger seat)
Release button
:
Head restraint height
;
Head restraint angle (luxury head
=
restraints only)
To raise: pull the head restraint up to the
X
desired position.
To lower: press release button : and slide
X
the head restraint down to the desired posi-
tion.
To adjust the angle: hold the front part of
X
the luxury head restraint by the lower edge
and tilt it to the desired position.
To remove: pull the head restraint up to
X
the stop.
Press release button : and pull out the
X
head restraint.
To insert: insert the head restraint so that
X
the rod with the detents is on the left when
viewed in the direction of travel.
Press and hold release button :.
X
Push the head restraint down until it
X
engages.