7.2.17 Console Redirection Submenu
This submenu appears when selecting [Console Redirection] from the [Server] menu.
Use this submenu to configure detailed settings for console redirection.
Console Redirection:
Item
Console Redirection
Port
Baud Rate
Protocol
Flow Control
Mode
PhoenixBIOS Setup Utility
Server
Console Redirection
[Disabled]
-/+
Change Values
Select Item
Select Menu
Enter
Select > Sub-Menu
table: Items on the Console Redirection Submenu
Setting
• Disabled (Initial value)
• Enabled
• Serial 1 (Initial value)
• Serial 2
• 1200
• 2400
• 4800
• 9600 (Initial value)
• 19.2K
• 38.4K
• 57.6K
• 115.2K
• VT100
• VT100, 8-bit
• PC-ANSI, 7-bit
• PC-ANSI
• VT100+ (Initial value)
• None
• XON/XOFF
• CTS/RTS (Initial value)
• Standard
• Enhanced (Initial value)
PRIMERGY RX300 S4 User's Guide
Item Specific Help
Description
Sets whether to enable or disable console
redirection.
Sets the serial port used for console redirection.
This submenu appears when [Console Redirection]
is set to "Enabled".
Sets the baud rate to be used for console redirection.
This submenu appears when [Console Redirection]
is set to "Enabled".
Sets the console type for console redirection.
This submenu appears when [Console Redirection]
is set to "Enabled".
Sets the flow control.
This submenu appears when [Console Redirection]
is set to "Enabled".
Sets the range of use for console redirection.
This submenu appears when [Console Redirection]
is set to "Enabled".
207