Repair; Replacing A Defective Fuse; Replacing A Defective Bulb - Otto Bock B400b400 Instructions For Use Manual

7.3 Repair

7.3.1 Replacing a defective fuse

INFORMATION
When replacing, only use fuses of the same type. Note the
rating printed on it.Note the rating printed on it.
The fuse (for values see section "Technical Data" > Table
"Electrical System") is located in a fuse holder underneath
the seat, next to the controller.
Removing the fuse
> The control unit is turned off.
1) Open the fuse holder cover.
2) Pull the fuse out of the spring contacts.
Installing the fuse
1) Remove the new fuse from the protective cover.
2) Centre the fuse on the spring contacts and insert it.
3) Close the fuse holder cover until you feel it engage.
B400
Fig. 41 Fuse holder, vertical (basic model); fuse holder, hori­
zontal
1 Fuse holder
2 Fuse cap

7.3.2 Replacing a defective bulb

NOTICE
Penetration of moisture
Risk of damage to the light
► During installation, ensure that the plates are seated
accurately in the housing.
► Ensure that the screws are seated tightly against the
plate.
Maintenance/Repair
3 Fuse
Ottobock | 63