Heat Sink - HP ENVY m6 Maintenance And Service Manual

Heat sink

NOTE: The heat sink spare part kit includes replacement thermal material.
Description
For use only with system boards with spare part numbers 760043-601, 760043-501, 760043-001,
782279-601, 782279-501 and 782279-001.
For use only with system boards with spare part numbers 760042-501 and 760042-001.
Before removing the heat sink, follow these steps:
1. Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2. Disconnect the power from the computer by unplugging the power cord from the computer.
3. Disconnect all external devices from the computer.
4. Remove the battery (see
a. Service cover (see
b. Hard drive (see
c. Base enclosure (see
d. Display assembly (see
e. Fan (see
f. System board (see
Remove the heat sink:
1. Turn the system board upside down, with the front toward you.
2. Following the 1 through 4 sequence stamped into the heat sink, loosen the four Phillips PM2.0×11.0
captive screws (1) that secure the heat sink to the system board.
Battery on page
WLAN module on page
Hard drive on page
Base enclosure on page
Display assembly on page
Fan on page 42)
System board on page
29), and then remove the following components:
30)
32)
38)
40)
43)
Component replacement procedures
Spare part number
764034-001
720539-001
47