Fan - HP ENVY m6 Maintenance And Service Manual

9. Remove the display assembly (2) from the computer.
Reverse this procedure to install the display assembly.

Fan

Description
Fan (includes cable)
Before removing the fan, follow these steps:
1. Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2. Disconnect the power from the computer by unplugging the power cord from the computer.
3. Disconnect all external devices from the computer.
4. Remove the battery (see
a. Service cover (see
b. Hard drive (see
c. Base enclosure (see
d. Display assembly (see
Remove the fan:
1. Disconnect the fan cable (1) from the system board.
2. Remove the two Phillips PM2.5×4.5 screws (2) that secure the fan to the top cover.
42 Chapter 6 Removal and replacement procedures for Authorized Service Provider parts
Battery on page 29), and then remove the following components:
WLAN module on page
Hard drive on page 32)
Base enclosure on page
Display assembly on page
30)
38)
40)
Spare part number
720235-001