Base Enclosure - HP ENVY m6 Maintenance And Service Manual

Base enclosure

Description
Base enclosure; includes red Beats logo
Base enclosure; includes grey Beats logo
Before removing the base enclosure, follow these steps:
1. Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2. Disconnect the power from the computer by unplugging the power cord from the computer.
3. Disconnect all external devices from the computer.
4. Remove the battery (see
5. Remove the solid-state drive (see
6. Remove the hard drive (see
Remove the base enclosure:
1. Remove the front rubber feet (1).
2. Remove the screw cover (2).
The front rubber feet and the screw cover are included in the Rubber Kit, spare part number
720559-001.
3. Remove the eight Phillips PM2.5×5.5 screws (2) that secure the base enclosure to the computer.
38 Chapter 6 Removal and replacement procedures for Authorized Service Provider parts
Battery on page 29).
WLAN module on page
Hard drive on page 32).
Spare part number
760035-001
774152-001
30).