Display Assembly - HP ENVY m6 Maintenance And Service Manual

Reverse this procedure to install the base enclosure.

Display assembly

Description
15.6-in, AntiGlare, FHD, LED, TouchScreen display assembly for use on all computer models
15.6-in, AntiGlare, HD, LED, TouchScreen display assembly for use on all computer models
To remove the display assembly and access the display assembly subcomponents, follow these steps:
1. Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2. Disconnect the power from the computer by unplugging the power cord from the computer.
3. Disconnect all external devices from the computer.
4. Remove the battery (see
5. Disconnect the wireless antenna cables from the WLAN module (see
6. Remove the hard drive (see
7. Remove the base enclosure (see
Remove the display assembly:
1. Release the wireless antenna cables from the retention clips built into the left rear speaker (1),
connector board (2), and top cover (3).
2. Release the wireless antenna cables from the retention clips (4) built into the subwoofer.
3. Release the ZIF connector to which the display panel cable is attached, and then disconnect the display
panel cable (5) from the system board.
4. Disconnect the the webcam/microphone module cable (6) from the system board.
5. Release the display panel cable and the webcam/microphone module cable from the clips and routing
channel built into the right rear speaker (7).
40 Chapter 6 Removal and replacement procedures for Authorized Service Provider parts
Battery on page 29).
Hard drive on page 32).
Base enclosure on page
Spare part number
788475-001
788474-001
WLAN module on page
38).
30).