Speakers - HP ENVY m6 Maintenance And Service Manual

Speakers

Description
Speakers (include left and right speakers, 2 cables, and 4 isolators)
Before removing the speakers, follow these steps:
1. Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2. Disconnect the power from the computer by unplugging the power cord from the computer.
3. Disconnect all external devices from the computer.
4. Remove the battery (see
a. Service cover (see
b. Hard drive (see
c. Base enclosure (see
Remove the speakers:
1. Disconnect the speaker cable (1) from the system board.
2. Release the speaker cables from the clips (2) and routing channel built into the top cover.
3. Remove the four Phillips PM2.5×6.2 screws (3) that secure the speakers to the top cover.
Battery on page 29), and then remove the following components:
WLAN module on page
Hard drive on page 32)
Base enclosure on page
30)
38)
Component replacement procedures
Spare part number
720561-001
55