Handlebar Grip; Throttle Control - Arctic Cat 2016 Alterra 500 Service Manual

AF778D
EPS005A
4. Connect the 2-pin and 8-pin connectors to the EPS
assembly.
5. Install the steering post housing with plate to the
frame and secure with two cap screws. Tighten to 20
ft-lb.
6. Install the handlebar and secure with the handlebar
caps. Tighten the screws to 25 ft-lb.
7. Install the shock absorber and tighten to 50 ft-lb.
8. Install the handlebar cap; then install the console and
gauge

Handlebar Grip

REMOVING
1. Loosen but do not remove the cap screws in the end
of the handlebar; then tap lightly on the head to dis-
lodge the handlebar plug.
XR121
20
XR123A
2. Grasp the end and remove the cap screw, plug, and
end cap.
INSPECTING
1. Inspect the grip for wear, cuts, or cracks.
2. Inspect the grip for deterioration.
3. If a grip is damaged, cut the grip lengthwise using a
sharp knife or box cutter; then peel off the grip.
INSTALLING

NOTE: Before installing a grip, use contact removal
spray or alcohol to clean the handlebar of glue resi-
due, oil, or any other contaminant.
1. Apply a liberal amount of Handlebar Grip Adhesive
to the inside of a new grip.
2. Slide the grip onto the handlebar until it is fully
seated with the smooth part of the grip facing up.
3. Wipe off any excess glue; then secure the grip with
the handlebar end-cap.

Throttle Control

REMOVING
1. Remove the two machine screws securing the throt-
tle control to the handlebar.
2. Slide the grommet out of the lower half of the throt-
tle control; then remove the cable from the actuator
arm.
AF676D
3. Remove the cap screw, lock washer, and washer
securing the actuator arm to the throttle control lever.