Handlebar Grip - Arctic Cat Y-12+ 2012 Service Manual

FOR ARCTIC CAT ATV DISCOUNT PARTS CALL 606-678-9623 OR 606-561-4983
8. Install the steering post access cover and secure with
four reinstallable rivets; then install and secure the
radiator access cover.
www.mymowerparts.com
FI464A
FI463A
FI466A
FI465A
Manual
Table of Contents

Handlebar Grip

REMOVING
1. Loosen but do not remove the cap screws in the end
of the handlebar; then tap lightly on the head to dis-
lodge the handlebar plug.
2. Grasp the end and remove the cap screw, plug, and
end cap.
INSPECTING
 NOTE: Whenever a part is worn excessively,
cracked, or damaged in any way, replacement is nec-
essary.
1. Inspect the grip for wear, cuts, or cracks.
2. Inspect the grip for deterioration.
3. If a grip is damaged, cut the grip lengthwise using a
sharp knife or box cutter; then peel off the grip.
INSTALLING
 NOTE: Before installing a grip, use contact removal
spray or alcohol to clean the handlebar of glue resi-
due, oil, or any other contaminant.
1. Apply a liberal amount of Handlebar Grip Adhesive
to the inside of a new grip.
2. Slide the grip onto the handlebar until it is fully
seated with the smooth part of the grip facing up.
Section
Table of Contents
KC310
KC309A
8
8-5