Lexmark C522 Service Manual page 53

User status and attendance messages (continued)
Error code
37 Insufficient memory,
some held jobs were lost
38 Memory Full
50 PPDS font error
51 Defective flash
detected
52 Not enough free
space in flash memory
for resources
53 Unformatted flash
detected
54 Serial option <x>
error
Action
• The printer was unable to restore some or all of the confidential or held jobs on the hard
disk.
Continue appears, and then press
• Press until
• If this message occurs again, replace the hard drive.
• If this does not fix the problem, replace the system card. See
page 4-79.
Continue appears, and then press
• Press until
continue printing.
The job may not print correctly.
• Cancel the current job.
• Install additional printer memory.
• If this does not fix the problem, replace the system card. See
page 4-79.
Continue appears, and then press
• Press until
continue printing.
The job may not print correctly.
• Cancel the current job.
• If this does not fix the problem, replace the system card. See
page 4-79.
• Press until Continue appears, and then press
continue printing.
• Install different flash memory before downloading any resources to flash.
• If this does not fix the problem, replace the system card. See
page 4-79.
• Press until Continue appears, and then press
continue printing.
Downloaded fonts and macros not previously stored in flash memory are deleted.
• Delete fonts, macros, and other data stored in flash memory.
• Install a larger capacity flash memory card.
• If this does not fix the problem, replace the system card. See
page 4-79.
• Press until Continue appears, and then press
continue printing.
• Format the flash memory before storing any resources on it. If the error message
remains, replace the flash memory.
• If this does not fix the problem, replace the system card. See
page 4-79.
• Make sure the serial link is set up correctly and the appropriate cable is in use.
• Make sure the serial interface parameters (protocol, baud, parity, and data bits) are set
correctly on the printer and host computer.
• Press until Continue appears, and then press
continue printing.
The job may not print correctly.
• POR the printer. If this does not fix the problem, replace the PCI card.
5022-xxx
to clear the message.
"System card removal" on
to clear the message and
"System card removal" on
to clear the message and
"System card removal" on
to clear the message and
"System card removal" on
to clear the message and
"System card removal" on
to clear the message and
"System card removal" on
to clear the message and
Diagnostic information
2-21