System Card Support Shield Removal - Lexmark C522 Service Manual

System card support shield removal

See "System card support shield, C52x" on page 7-9
for the part number.
1.
Remove the right cover. See
2.
Remove the left cover. See
3.
Remove the LVPS. See
4.
Remove the system card. See
5.
Remove the five mounting screws (A) from the outer left side of the printer.
Note: Make a note of the attachment of the printhead ground cable (B) to the second screw from the
bottom for later installation.
6.
Remove the four screws (C) from the inner right side of the support shield.
7.
Pull the cables through the access holes on the right side of the printer.
8.
For network printers—Remove the two screws (D) attaching the parallel connector support plate.
For non-network printers—Remove the INA mounting plate screw (E) and the INA mounting plate.
"Right cover removal" on page
"Left cover removal" on page
"Low voltage power supply (LVPS) removal" on page
"System card removal" on page
or "System card support shield, C53x" on page 7-9
4-26.
4-20.
4-79.
5022-xxx
4-65.
4-81
Repair information