Lexmark C522 Service Manual page 42

5022-xxx
Service error codes and paper jam messages (continued)
Error code
201.10
201.21
201.23
201.24
202.02
202.12
202.13
2-10
Service Manual
Description
Input sensor flag broke early.
Possible causes:
• Paper jam leaving page over
sensor
• Defective input sensor
• Faulty system card
Cartridge motor 1 (top) or cartridge
motor 2 (bottom) has stalled.
Possible causes:
• Faulty cable/connector
• Faulty cartridge motor
• Faulty system card
Special case.
Possible cause:
• System card code failure
A 201.08 jam occurred and was not
cleared.
Possible cause—Failure to open and
close the top access door.
Exit sensor is made when printer tries
to print from an idle state.
Possible causes:
• Damaged paper exit sensor or
paper exit sensor flag
• Damaged fuser autoconnect
• Faulty fuser DC cable connection
• Faulty fuser
• Faulty system card
Exit sensor broke early.
Possible causes:
• Damaged paper exit sensor or
paper exit sensor flag
• Faulty fuser
• Faulty system card
Exit sensor never broke.
Possible causes:
• Damaged paper exit sensor or
paper exit sensor flag
• Faulty fuser
• Faulty system card
• Faulty output bin flag
Action
• Check for anything in the paper path that might
cause the paper to jam.
• If clearing a paper jam does not fix the problem,
go to "Input sensor service check" on
page 2-52.
• Check for anything in the paper path that might
cause the paper to jam.
• If clearing a paper jam does not fix the problem,
go to "143.xx—Motor (EP drive assembly top
cartridge) error service check" on page 2-34
and then "144.xx—Motor (EP drive assembly
bottom cartridge) error service check" on
page 2-35 if necessary.
• POR the printer. Replace the system card if the
error message persists. See
removal" on page 4-79.
• If replacing system card does not fix the
problem, contact your next level of support.
This error is generated as a protection for possible
paper wrap in the fuser. Open the top access door,
and check for a paper jam. Close the top access
door. If the jam is cleared, and the error does not go
away, go to "Exit sensor service check" on
page 2-52.
• Check for anything in the paper path that might
cause the paper to jam.
• The fuser exit sensor may not be functioning
properly. See "Exit sensor service check" on
page 2-52.
The fuser exit sensor may not be functioning
properly. See "Exit sensor service check" on
page 2-52.
• Check output bin flag on fuser for proper
operation. Ensure that paper is not hanging on
the flag.
• The fuser exit sensor may not be functioning
properly. See "Exit sensor service check" on
page 2-52.
"System card