Photoconductor Unit Removal - Lexmark C522 Service Manual

5022-xxx

Photoconductor unit removal

Warning: To avoid damaging the photoconductor drum, hold the photoconductor units by their handle and
place the photoconductor units on a clean surface. See
page 4-2
1.
Open the top access door.
2.
Open the front access door.
3.
Lift the right end handle (A) of the photoconductor unit, releasing from the mount.
4.
Lift the unit up and away from the left side of printer, ensuring the left end of the photoconductor is released
from the holding pin (B).
B
Installation note: If a new photoconductor unit is installed, reset the life count value in the printer memory.
•
If a message appears on the operator panel:
1.
When 84 <color> PC Unit Life Warning or 84 Replace <color> PC Unit appears,
select Supply Replaced, and then press
Replace Supply displays.
2.
Select Cyan PC Unit, Magenta PC Unit, Yellow PC Unit, or Black PC Unit based on the
photoconductor unit that was just replaced, and then press
<color> PC Unit Replaced displays.
3.
Select Yes, and then press
•
If no message appears:
1.
Press
2.
Select Supplies Menu, and press
3.
Press
4.
Select Cyan PC Unit, Magenta PC Unit, Yellow PC Unit, or Black PC Unit based on the
photoconductor unit that was just replaced, and then press
<color> PC Unit Replaced displays.
Press
4-70
Service Manual
for additional information.
to clear the message.
.
to select Replace Supply.
to select Yes.
"Handing the photoconductor unit" on
.
.
.
.
A