Enforce Color Order; Color Alignment; Motor Calibration; Paper Prompts - Lexmark C522 Service Manual

5022-xxx

Enforce Color Order

Lets the system support person set whether the color order of the cartridges inside the printer is enforced and if
messages appear.
From top to bottom, as indicated by the color labels in the printer, the enforced toner cartridges order is yellow,
cyan, magenta, and black.
When On is selected, the printer lets users place each toner cartridge in only its specified slot. For instance, the
Magenta toner cartridge must be in the Magenta slot. If the user tries to place a cartridge in an incorrect slot, the
printer message 31 Defective or Missing [color] Cartridge or 32 Unsupported [color]
Cartridge appears where [color] stands for Cyan, Magenta, Yellow, or Black.
When Off is selected, the printer does not issue any message to let the user know that the cartridge is placed in
the wrong slot inside the printer.

Color Alignment

Prints the Print Alignment Page and requires that the best line in each set of lines must be selected.
Press Select to begin printing.
Consulting the printed page, follow the instructions on the operator panel to choose the best appearing line
numbered 0 through 20 for the following sets of lines. These includes Set A, Set B, and so forth through Set L.
For each of the sets listed, the sub-value is 0–20 (10 is the default).

Motor Calibration

Allows for speed calibration after resetting the fuser maintenance counter.
To calibrate the motors:
Press to select Motor Calibration from the CONFIG MENU. Calibrating displays, and the printer prints
several blank pages and then returns to the CONFIG MENU.

Paper Prompts

Controls the source the printer selects for a change paper source message. The printer displays the change
paper source message based on the size of the paper requested and not by the paper type.
Selections include Auto, MP Feeder, and Manual Paper. MP Feeder is only available on some printer models.
Note: If the Configure MP setting is changed to Manual, a power-on reset is performed, and the value of the
Paper Prompts menu item before the power-on reset was MP Feeder, then when the printer restarts, the printer
automatically changes the Paper Prompts setting to Manual Paper.
Load Manual overrides that would result in a change paper message are disabled for Paper or Env prompts that
are set to Manual, Manual Paper, or Manual Env.
3-24
Service Manual