Samsung CLX-9201 Service Manual page 323

► Error Code
H2–6736 ~ H2–6743
► Error message
Finisher Failure: #H2-67xx. Check finisher
► Symptom
Main Tray does not move to or leave home position.
► Troubleshooting method
1) If there is jammed paper on the Main Tray, removing paper manually. Open and close finisher stapler door or jam
cover to check if finisher executes initialization process.
2) If Main Tray still doesn't go back to home position and error does not disappear, follow the instructions below:
a) Does finisher input sensor (Standby & Home sensor) work well?
i) Make sure finisher input sensor cable is connected well to the sensor connector.
ii) Make sure finisher input sensor cable is connected well to the main board connector.
iii) Replace the finisher input sensor(JC81–09686A).
(Refer to 3.3.34.1 Finisher Main Motor)
iv) Replace the finisher main board(JC81–09692A).
(Refer to 3.3.34.2. Finisher Board)
b) Does finisher Main Tray motor work well?
i) Make sure finisher Main Tray motor cable is connected well to the motor connector.
ii) Make sure finisher Main Tray motor cable is connected well to the main board connector.
iii) Replace the finisher Main Tray motor(JC81–09679A).
(Refer to 3.3.34.1 Finisher Main Motor)
iv) Replace the finisher main board(JC81–09692A).
(Refer to 3.3.34.2. Finisher Board)
c) Do finisher Main Tray parts work well?
i) Make sure Main Tray parts can move or rotate smoothly.
ii) Make sure there are no mechanical interference to stop moving or rotating.
iii) Make sure the belt is tight in the correct position, if it has a belt.
d) Does finisher Main Tray motor gear set work well?
i) Make sure gear set can rotate smoothly.
ii) Make sure each gear is not broken.
Copyright© 1995-2013 SAMSUNG. All rights reserved.
4. Troubleshooting
4-140