Samsung CLX-9201 Service Manual page 320

4. Troubleshooting
► Error Code
H2–6734
► Error message
Finisher Failure: #H2-6734. Check finisher
► Symptom
Finisher stapler cartridge refill failed.
► Troubleshooting method
1) Open finisher stapler door to refill cartridge and then close door. Self-Priming will execute automatically if
necessary. If stapler error or warning does not disappear, follow the instructions below :
a) Does finisher stapler cartridge refill box fit well?
i) Make sure stapler refill box fit well into cartridge.
ii) Make sure staples do not jam near stapler head.
b) Does finisher stapler input sensor work well?
i) Make sure finisher input sensor cable is connected well to the sensor connector.
ii) Make sure finisher input sensor cable is connected well to the main board connector.
iii) Replace the finisher stapler(JC81–07376A).
iv) Replace the finisher main board(JC81–09692A).
(Refer to 3.3.34.2. Finisher Board)
c) Does finisher stapler motor work well?
i) Make sure finisher stapler motor cable is connected well to the stapler motor connector.
ii) Make sure finisher stapler motor cable is connected well to the main board connector.
iii) Replace the finisher stapler(JC81–07376A).
iv) Replace the finisher main board(JC81–09692A).
(Refer to 3.3.34.2. Finisher Board)
d) Check if any debris (staple) is present. Please make sure to remove any debris.
4-137 Copyright© 1995-2013 SAMSUNG. All rights reserved.