H2-Xxxx (Finisher) Type Error Code - Samsung CLX-9201 Service Manual

4. Troubleshooting

4.5.4. H2-xxxx (Finisher) type error code

► Error Code
H2–6700
H2–6701
H2–6702
H2–6703
H2–6704
H2–6705
► Error message
Paper jam inside of finisher
Paper jam at exit of finisher
► Symptom
Paper failed to pass finisher's paper transportation path within the specified time.
► Troubleshooting method
1) Open finisher jam cover, and make sure that the paper is on the paper path. If there is paper, remove paper manually.
2) If the error does not disappear even after removing paper and closing finisher jam door, follow the instructions
below:
a) Does finisher input sensor work well?
i) Make sure finisher input sensor cable is connected well to the sensor connector.
ii) Make sure finisher input sensor cable is connected well to the main board connector.
iii) Replace the finisher input sensor(JC81–09686A).
(Refer to 3.3.34.1 Finisher Main Motor)
iv) Replace the finisher main board(JC81–09692A).
(Refer to 3.3.34.2. Finisher Board)
b) Check if any debris is present. Please make sure to remove any debris.
4-131 Copyright© 1995-2013 SAMSUNG. All rights reserved.