Samsung CLX-9201 Service Manual page 303

c) If the connection is OK, replace the feed sensor(0604-001381).
d) Install the DCF pick up unit1.
5) If the problem persists after checking step 3~4, check the following :
a) Remove the DCF pick up unit1. Check if the sensor and actuator are assembled correctly.
b) When pushing the pickup lever, check if the pick up rollers are down.
c) Replace the DCF pick up unit1(JC93-00513A) or defective part.
6) Check the DCF feed motor.
a) Check if the DCF feed motor cable is connected correctly.
b) If the connection is OK, replace the DCF feed drive unit(JC93-00447A).
(Refer to 3.3.33.2 DCF Feed Motor)
7) Check the DCF pick up motor.
a) Check if the DCF pick up motor cable is connected correctly.
b) If the connection is OK, replace the DCF pick up drive unit(JC93-00442A).
(Refer to 3.3.33.3 DCF Pick Up Motor)
Copyright© 1995-2013 SAMSUNG. All rights reserved.
4. Troubleshooting
4-120