Brake Caliper - Sym EuroMX 125 Service Manual

Brake Caliper

Removal
Place a container under the brake caliper, and
loosen the brake hose bolt and finally remove the
brake hoses.
CAUTION
•
Do not spill brake fluid on painted surfaces.
•
The exhaust pipe has to be removed
before remove the rear brake caliper.
Remove the bolt cap, and loosen the lining guide
bolt.
Remove two caliper bolts and the caliper.
INSTALLATION
Install the brake caliper and tighten the attaching
bolts securely.
Torque: 3.3 kgf-m
CAUTION
•
Use M8 x 35 mm flange bolt only.
•
Long bolt will impair the operation of brake
disc.
Tighten the lining guide bolt.
Torque: 1.8 kgf-m
Install the bolt cap.
Torque: 1.0 kgf-m
Use two seal washers and hose bolts to lock the
hose and brake caliper in place.
Torque: 3.5 kgf-m
Refill up the brake fluid to the reservoir and make
necessary air bleeding.
This Chapter Contents
Bolts x 2
13. Brake
Front brake caliper
Rear brake caliper
13-7