Disassembly Of Final Driving Mechanism; Inspection Of Final Driving Mechanism - Sym EuroMX 125 Service Manual

Disassembly of Final Driving
Mechanism
Remove the rear wheel. (refer to chapter 15)
Remove the clutch.
Drain gear oil out from gear box.
Remove gear box cover bolts (7 bolts) and then
remove the cover and the final driving shaft.
Remove gasket and setting pin.
Remove countershaft and gear.
Remove final driving gear and shaft.
Inspection Of Final Driving
Mechanism
Check if the countershaft and the gear are wear
out or damage.
Check if the final driving shaft and gear are burn,
wear or damage.
This Chapter Contents
7 bolts
Countershaft
gear
Driving shaft
9. Final Driving Mechanism
Final driving shaft
Countershaft
Final driving
gear
9-3