Sym EuroMX 125 Service Manual page 106

Clutch Block Replacement
Remove snap and washer, and the remove
clutch block and spring from driving plate.
Check if spring is damage or insufficient
elasticity.
Check if shock absorption rubber is damage or
deformation. Replace it if necessary.
Apply with grease onto setting pins.
Apply with grease onto setting pins. But, the
clutch block should not be greased. If so, replace
it.
Install new clutch block onto setting pin and then
push to specified location.
Caution
• Grease or lubricant will damage the clutch
block and effect the block's connection
capacity.
Install the spring snap into groove with pliers.
This Chapter Contents
8. V-Belt Driving System/Foot Starter
Clutch block
Shock absorption
rubber
Clutch block
Spring
Shock absorption
rubber
Spring
Driving
plate
Snap ring
Setting pin
8-11