Sym EuroMX 125 Service Manual page 155

13. Brake
INSTALLATION
Place the master cylinder onto handlebar, and
install the split ring and bolts. The "UP" mark on
the split ring should face upward.
Align the split ring on the master cylinder seat
with the alignment point on the handlebar.
Tighten the upper bolt of the seat to specified
torque value, and then tighten lower bolt to the
same specified torque value.
Install the brake lever, and connect leads to
brake lamp switch.
Connect brake hoses with 2 new washes.
Tighten the brake hose bolt to the specified
torque value.
Torque value: 3.5 kgf-m
Make sure the hose is installed correctly.
CAUTION
Improper routing may damage leads, hoses
or pipes.
CAUTION
Kink of brake leads, hose or pipe may
reduce brake performance.
Add specified brake fluid and bleed the system
and conduct the air-bleeding job for the system.
13-10
This Chapter Contents
Punch
point
Split ring
Master cylinder
Mounting
seat
"UP" mark
Sealing washer
Hose bolt
Brake hose