Sym EuroMX 125 Service Manual page 122

Installation
Install the components in the reverse procedures
of removal.
Caution
Add adhere seal onto the thread of hex
socket bolt.
Torque value: 1.0~1.4 kgf-m
Starting clutch Installation
Install idle gear shaft and idle gear.
Install starting clutch.
Install the starting driven gear onto the starting
clutch.
Hold the starting driven gear with the universal
fixture.
Tighten the 22mm anti-loosen mounting nut and
gasket.
Caution
Add engine oil onto the thread of mounting
nut.
Special service tools:
Anti-loosen mounting nut socket
Universal fixture.
Torque value: 9.0~10.0 kgf-m
This Chapter Contents
10. Alternator/Starting Clutch
Clutch body
Mounting nut
Plug Spring
Clutch cover
Mounting nut socket
Roller
10-7