Right Crankcase Cover Installation; Mounted Coil Set Installation; Flywheel Installation - Sym EuroMX 125 Service Manual

10. Alternator/Starting Clutch

Right Crankcase Cover Installation

Install setting pin and new gasket on the
crankcase.
Replace the right crankshaft oil seal of the
crankcase and apply some oil onto the oil seal
lip.
Install right crankcase cover onto the right
crankcase. (8 bolts)
Torque value: 1.5~2.0 kgf-m

Mounted Coil Set Installation

Install the coil set onto right crankcase cover. (2
screws)
Install crankshaft position sensor. (2 screws)
Tighten the cable guide. (2 screws)
Torque: 1.5~2.0 kgf-m
Tie the wire harness hose onto the indent of
crankcase.
Caution
Make sure that the wire harness is placed
under the crankshaft position sensor.
Connect the connectors of alternator and
crankshaft position sensor.

Flywheel Installation

Make sure that there is no magnetic powder. If
so, clean up it.
Align insert on crankshaft with the flywheel
groove, and then install the flywheel.
Hold the flywheel with flywheel holder, and
tighten its nut.
Torque value: 5.0~6.0 kgf-m
Special service tool:
Universal fixture
10-8
This Chapter Contents
Cable guide
Coil
Alternator coupler
8 bolts
Pulse
generator
Pulse generator
coupler
Universal fixture