Subaru 2002 IMPREZA Service Manual page 88

DRAIN FILTER
EMISSION CONTROL
(AUX.
EMISSION CONTROL DEVICES)
12.Drain Filter
A: REMOVAL
1) Disconnect the ground terminal from battery.
2) Lift-up the vehicle.
3) Remove the canister. <Ref. to EC(D0HC TUR-
BO)-6, REMOVAL, Canister.>
4) Disconnect the connector from drain valve.
/
0
H2M3611
5) Disconnector the evaporation hoses (A) from
joint pipes.
6) Remove the bolt which installs the drain filter and
drain valve brackets on body, and remove them as
a unit.
7) Disconnect the evaporation hoses, and remove
the drain filter.
I
B2M 1791 C
B: INSTALLATION
Install in the reverse order of removal.
Tightening torque:
23 N-m
( 2 . 3
kgf-m, 17 ff-lb)
C: INSPECTION
1) Make sure all hoses are installed correctly.
2) Make sure the hoses are not cracked or loose.
EC(D0HC TURBO)-14