Subaru 2002 IMPREZA Service Manual page 145

ENGINE ASSEMBLY
MECHANICAL
(6) Tighten the plug.
44 N-m (4.5 kgf-m, 32.5 ff-lb)
Tightening torque:
2) Install the front cushion rubbers to engine.
Tightening torque:
3) Install the engine onto transmission.
34 N-m (3.5 kgf-m, 25.3 ft-lb)
(1) Position the engine in engine compartment
and align it with transmission.
CAUTION:
Be careful not to damage adjacent parts or
body panels with crank pulley, oil pressure
gauge, etc.
(2) Apply a small amount of grease to splines of
mainshaft. (MT vehicles)
4) Tighten the bolts which hold right upper side of
transmission to engine
Tightening torque:
50 N.m (5.1 kgf-m, 36.9 ff-lb)
B2M2791
5 ) Remove the lifting device and wire ropes.
6) Remove the garage jack.
7) Install the pitching stopper.
Tightening torques
T I : 50 N-m (5.1 kgf-m, 37 ff-lb)
T2: 58 N.m
(5.9
kgf-m, 43 ff-lb)
8) Remove the ST from torque converter clutch
case. (AT vehicles)
NOTE:
Be careful not to drop the ST into the torque con-
verter clutch case when removing ST.
ST 498277200 STOPPER SET
9) Install the starter. <Ref. to SC-7, INSTALLA-
TION, Starter.>
ME(D0HC TURBO)-39