Subaru 2002 IMPREZA Service Manual page 576

DIAGNOSTIC PROCEDURE WITH DIAGNOSTIC TROUBLE CODE (DTC)
ENGINE (DIAGNOSTICS)
Yes
20 to step 8.
30 to step 9.
Step
CHECK INHIBITOR SWITCH GROUND LINE.
Measure the resistance of harness between
inhibitor switch connector and engine ground.
Connector & terminal
(T7) No. 7
-
Engine ground:
No
Repair open circuit
in harness
between inhibitor
switch connector
and starter motor
ground line.
NOTE:
In this case, repai,
the following:
Open circuit in
harness between
inhibitor switch
connector and
starter motor
ground line
Poor contact in
starter motor con-
nector
Poor contact in
starter motor
ground
Starter motor
Replace the inhibi,
tor switch. <Ref. to
AT-28, Inhibitor
Switch.>
CHECK INHIBITOR SWITCH.
Measure the resistance between inhibitor
switch connector receptacle's terminals in
selector lever "N" and " P positions.
Terminals
NO. 7 - NO. 12:
CHECK SELECTOR CABLE CONNECTION.
3epair selector
Check
s the resistance less than 5
2?
Contact with SOA
s the resistance less than 1
2?
:able connection.
<Ref. to CS-27,
INSPECTION,
Select Cable.>
s there any fault in selector
:able connection to inhibitor
;witch?
(distributor) ser-
vice.
NOTE:
Inspection by DTL
is required, be
cause probablc
cause is deteriora
tion of multiplf
parts.
EN(D0HC TURBO)-352