Subaru 2002 IMPREZA Service Manual page 180

CYLINDER BLOCK
MECHANICAL
26) Draw out the piston pin from #1 and #2 pistons
27) Similarly remove the piston pins from #3 and #4
using ST.
ST 499097700 PISTON PIN REMOVER
CAUTION:
Be careful not to confuse the original combina-
tion of piston, piston pin and cylinder.
I
I
pistons.
28) Remove the bolts which connect cylinder block
on the side of #2 and #4 cylinders.
29) Back off the bolts which connect cylinder block
on the side of #1 and #3 cylinders two or three
turns.
30) Set up the cylinder block so that #1 and #3 cyl-
inders are on the upper side, then remove the cyl-
inder block connecting bolts.
31 ) Separate the left-hand and right-hand cylinder
blocks.
CAUTION:
When separating the cylinder block, do not al-
low the connecting rod to fall and damage the
cylinder block.
\ +
G2M0166
B2M2408r
(1)
Cylinder block
(2) Rear oil seal
(3) Crankshaft
(4)
Crankshaft bearing
(5) Piston
. .
\ ,
32) Remove the rear oil seal.
33) Remove the crankshaft together with connect-
ing rod.
34) Remove the crankshaft bearings from cylinder
block using a hammer handle.
CAUTION:
Do not confuse the combination of crankshaft
bearings.
Press the bearing at the end opposite to locking
lip.
35) Draw out each piston from cylinder block using
a wooden bar or hammer handle.
CAUTION:
Do not confuse the combination of piston and
cylinder.
ME(D0HC TURBO)-74