D
Insert the 12 size 8 screws manually manipulating
them thus tightening them to the coupling at 25 N·m.
Insert the remaining M6 screws manually manipulating
them and tighten them to the coupling at 10 N·m.
Tighten all the screws inversely to the order
they were disassembled.
Install the heat exchanger with the O-Ring and lock the
support screws at a 10 N·m torque, the exchanger alu-
minium screw at a 15 N·m torque.
Always replace the aluminium seal washer at reassem-
bly.
Crankcase
- 34 -