Table of Contents
Advertisement
Crankcase
Clutch reassembly
Reposition the thrust washer with the smaller diameter
facing the engine. Fit the spacer, the roller cage, the
clutch drum and the washer. Since the washer in front
D
of the clutch drum is obtained by blanking, it has a
sharp edge and a rounded edge. Fit the washer so that
the rounded edge faces the engine.
Install the flange with the six columns, already assem-
bled (torque 4.5 Nm).
Fit in the disk-holder and angle it so the bearings fit into
their housing on the flange.
Install the two springs (as shown in the Figure), the
washer and the nut.
- 8 -
Hide quick links:
Advertisement
Chapters
Table of Contents
