MV Agusta 2008 F4 312RR 1078 Workshop Manual page 92

H)Separate the two carters (1 and 2) by manipulating
the protrusions.
D
I) If necessary remove the bearings (3).
L) Slide the motor shaft out.
In the event that the bushings should be temporarily
removed (4) it is a good idea to identify the bearing
number and its carter with a number using a marker.
For example the bushing removed from the n°1
bearing of the superior carter (starting from the left)
will be identified by the mark S1.
For the couplings refer to the groups they belong to
shown on the chart.
SELECTION TABLE FOR F4 BEARINGS
A 34,981
BENCH
34,988
PIN
B 34,989
DIAMETER
34,997
FUNCTIONING PLAY 0,012/0,038
BEDPLATE SLOT DIAMETER
38,103 38,112
A B
38,111 38,119
1.546/1,551 1,550/1,555
BLUE YELLOW
1,542/1,547 1,546/1,551
RED BLUE
Crankcase
2
3
- 30 -
1