MV Agusta 2008 F4 312RR 1078 Workshop Manual page 87

Crankcase
Free wheel starting
Remove the clutch and gear indicated in the relative
paragraphs.
Slide out the intermediate starting gear pin, first disas-
D
semble the pin-blockage plate.
Slide the intermediate gear.
Slide the alternator flange and generator shaft out.
If necessary disassemble the male torsion from the
generator using tool 800094794 to unscrew the nut.
Disassemble the generator command shaft using the
appropriate 800094795 blockage tool to unscrew the
screws.
Disassemble and verify the free wheel state.
Reassemble the free wheel with the seeger turned
towards the inside; to facilitate the procedure, insert
the part where the seeger is opened last. Verify that
the free wheel only turns clockwise.
Assemble the group on the tool 800094795 and block
the screw with a dynamometric key at 25 N·m and
MEDIUM THREAD BLOCKER.
800094794
Reassemble the male torsion joint on the generator
tightening nut with STRONG THREAD BLOCKER at
55 N·m.
Turn the oil drainage hole downwards present on the
flange.
Tighten the screws with MEDIUM THREAD BLOCKER
at 10 N·m.
Insert the starting gear with the smaller toothing turned
inwards from the gear end.
Insert the pin from the clutch end.
Assemble the pin-blockage plate fastening the screw
with MEDIUM THREAD BLOCKER.
Neutral switch
This component does not call for maintenance. In the
case of a malfunction, substitute the switch. When
reassembling it insert the switch with the help of a tube
key and tighten at 10 N·m.
800094795
- 25 -