MV Agusta 2008 F4 312RR 1078 Workshop Manual page 90

Crankcase
Oil cup
10 N•m
Remove the oil cup by means of the 6 mm tightening
screws.
D
Always substitute the gasket during reassembly.
Check to be sure that the oil inlet filter is integral with
no cracks or slits; clean it with compressed air at a low
pressure blown from the inside towards the outside.
To remove the oil inlet filter unscrew the tightening
screws. At reassembling tighten the 2 screws at 8 N·m
and block them with MEDIUM THREAD BLOCKER
after having carefully degreased them.
Position the gasket and manually bring the screws
closer.
Tighten the cup screws at 10 N·m.
- 28 -