Removing The "Padded" Armrest; Adjusting A Channel Forearm Pad With Swivel Unit - Otto Bock Ventus Instructions For Use Manual

Folding for transport (example: "Standard" side panel)
The side panels can be folded in for transport.
1) Fold the side panels up out of the side panel supports (see Fig. 24).
2) Fold the side panels inwards by 90° (see Fig. 25).
3) After assembling the wheelchair, fold the side panels down again into the guides of the side panel supports.

6.3.3.3 Removing the "Padded" armrest

To make getting in and transporting the wheelchair easier, the armrests can be folded away or removed.
1) Pull the armrests up out of the holders (see Fig. 26).
2) Fold the armrests away by 90° (see Fig. 27) or remove them.
3) After getting in, slide the armrests down into the holders again.

6.3.3.4 Adjusting a Channel Forearm Pad with Swivel Unit

INFORMATION
After adjusting the swivel unit, please always make sure that the lock pins have safely snapped in place.
The swivel unit allows the support angle and the rotation setting of a channel forearm pad to be adjusted independ­
ently.
Adjusting the support angle
1) Pull the release button outwards (see Fig. 28, item 1).
2) Lift up the channel forearm pad at the front end and adjust it to the desired angle (see Fig. 28, item 2).
3) Let go of the release button. The channel forearm pad will be secured in its position.
Adjusting the rotation setting in 15° steps
1) Pull the release button downwards (see Fig. 29, item 1).
2) Move the channel forearm pad to the desired rotation setting (see Fig. 29, item 2).
3) Let go of the release button. The channel forearm pad will be secured in its position.
Ventus
24
26
Usage
25
27
Ottobock | 19