Options; Storage; Preparation For Use; Assembly - Otto Bock Ventus Instructions For Use Manual

Preparation for Use

• Aluminium frame (open frame) with castor attachment device
• Fold-down back
• Single-panel footrest
• Aluminium side panels
• Calf strap
• "Standard" seat upholstery
• Rear wheels with quick-release axles
• Sliding and clamping rear wheel attachment devices (sliders)
• Wheel locks
• Castor wheel in castor fork with threaded axle, adjustable castor journal
• Push handles
The seat cushion is not part of the standard equipment.

4.3 Options

The standard model can be fitted to the user's personal requirements thanks to a large range of options. For use of
these options: see Page 13.

4.4 Storage

The wheelchair must be stored dry. The ambient temperature must be maintained between -10°C and +40°C.
Wheelchairs with PU tyres should not be stored for prolonged periods with the knee-lever brake applied as the
tyres could be deformed.
INFORMATION
Tyres contain chemical substances that can react with other chemical substances (such as cleaning agents,
acids, etc.).
5 Preparation for Use

5.1 Assembly

CAUTION
Exposed pinch points
Risk of crushing or pinching the fingers due to incorrect handling
► When folding out the backrest, only grip by the specified components.
CAUTION
Failure to check that the wheelchair is ready for use
Risk of falling, tipping of the user
► Before using the wheelchair for the first time, check the pre-settings with the support of the qualified person­
nel.
► After every assembly, check the proper mounting of the rear wheels. The wheel axles must be securely locked
in the fitting.
► Pay attention in particular to the stability against tipping, free running of the rear wheel and correct function of
the brakes.
► Check the tyre inflation pressure. The correct air pressure is printed on the sidewall of the tyre. For rear
wheels, the minimum air pressure is 7 bar. Ensure that both tyres are inflated to the same pressure.
INFORMATION
For details of weights of the individual parts, see the section "Technical Data".
For disassembly and transport, see the section "Disassembly/Transport".
A few simple steps are sufficient for preparing the wheelchair for use:
1) Fold down the backrest (see Fig. 2):
→ Pull the backrest cable until the locking mechanism releases.
→ Fold the backrest rearwards until the locking bolts lock in on both sides.
12 | Ottobock Ventus