Headrests And Neckrests; Additional Options; Disassembly / Transport - Otto Bock Ventus Instructions For Use Manual

6.3.11 Headrests and neckrests

The user may adjust the movable blocks of the headrest according to his/her preferences. Adjust the movable
blocks into the desired position and tighten the wrench bolts to fix the headrest in place.
The option has been preset by the qualified personnel.

6.3.12 Additional options

The product may be equipped with additional options.
The options are firmly mounted to the product by qualified personnel or the manufacturer and are pre-adjusted by
qualified personnel at delivery.

6.4 Disassembly / Transport

NOTICE
Impermissible loading of the folded-in backrest
Deformations, problems when unfolding
► Never rest heavy objects on the backrest when it is folded in.
The wheelchair must be prepared for transport in a passenger vehicle.
The small folded size (with the backrest folded) allows the product to be stored in a small vehicle trunk or on the
passenger seat.
1) Fold in the side panels (see Fig. 52):
→ Fold back the side panels out of the side panel supports.
→ Fold the side panels inwards by 90°.
2) Remove the seat cushion from the hook-and-loop fastener.
3) Remove the rear wheels:
→ Press in the button on the quick-release axle (see Fig. 53).
→ Pull the rear wheel outwards out of the quick-release axle housing.
NOTE: For the "lock-release assist" option, see the section "Rear Wheels".
4) Fold in the backrest (see Fig. 54):
→ Pull the backrest cable until the locking mechanism releases.
→ Fold the backrest down towards the seat surface and press until the locking bolts lock in on both sides.
5) Place the wheelchair in its folded-up state in the vehicle (see Fig. 55).
Ventus
52
Usage
53
Ottobock | 27