Legal Information; Service Life; Liability; Ce Conformity - Otto Bock Ventus Instructions For Use Manual

9 Legal Information

9.1 Service life

Based on market observations and the current state of technology, the manufacturer has calculated that the
product can be used for a period of 4 years, provided that it is used properly and that the service and maintenance
instructions are observed. Storage times at the dealer or with paying parties are not included in this period.
However, we would like to emphasise that the product is reliable far beyond this defined period of time, provided
that it is cared for and maintained properly.
If the service life is reached, the user or a responsible attendant should contact the qualified personnel who fitted
the product or the manufacturer's service (see inside or outside of rear cover for address).

9.2 Liability

The manufacturer's warranty applies only if the device has been used under the conditions and for the purpose
described. The manufacturer recommends that the device be used and maintained according to the instructions for
use.
The manufacturer is not responsible for damages caused by components and spare parts not approved by the
manufacturer. Repairs must be carried out exclusively by authorised dealers or by the manufacturer.

9.3 CE Conformity

This device meets the requirements of the 93 / 42 / EEC guidelines for medical devices. This device has been clas­
sified as a class I device according to the classification criteria outlined in appendix IX of the guidelines. The
declaration of conformity was therefore created by the manufacturer with sole responsibility according to appendix
VII of the guidelines.

9.4 Warranty terms

More information on the warranty terms and conditions is available from the qualified personnel who adapted the
product or from the manufacturer's service department (see back inside cover or back cover for addresses).

9.5 Trademarks

All denotations within this accompanying document are subject to the provisions of the respective applicable trade­
mark laws and the rights of the respective owners, with no restrictions.
All brands, trade names or company names may be registered trademarks and are subject to the rights of the
respective owners.
Should trademarks in this accompanying document fail to be explicitly identified as such, this does not justify the
conclusion that the denotation in question is free of third-party rights.

10 Technical Data

General information
Maximum load capacity [kg]
Weight [kg]
(for seat width 440 mm; 4" full rubber caster wheels, 24"
hollow rim)
Transport weights [kg]
(for seat width: 440 mm; 4" full rubber caster wheels)
Seat width [mm]
Seat depth [mm]
Max. total height [mm]
(for rear seat height: 500 mm; back height 500 mm; push
handle)
Turning circle approx. [mm]
(for seat width 440 mm; seat depth 500 mm)
Min. tyre pressure [bar]
Maximum permissible inclination [°]
Ventus
3)
Ventus
100 (for seat width 280 - 440)
140 (for seat width 460 - 500)
1)
approx. 12.5
1)
Frame: 7.5 – 8.8
1)
Rear wheel 24": 3.7
280 – 440 (max. load capacity 100 kg)
280 – 500 (max. load capacity 140 kg)
2)
300 – 500
1050
1150 (without wheelbase extension)
1250 (with wheelbase extension)
4)
7
5)
10
Legal Information
Ottobock | 31