Getting Into The Wheelchair/Transfers; Information On Use; Footrests - Otto Bock Ventus Instructions For Use Manual

Usage

6.2 Getting into the wheelchair/transfers

CAUTION
Incorrect handling when getting in
Risk of falling, tipping or rolling away due to incorrect handling
► Activate the wheel lock each time before you get into or out of or transfer to or from the wheelchair.
► Always get into the wheelchair from the side, where possible.
Getting into the wheelchair is described here in combination with transfer from one wheelchair to another.
The wheelchair is designed for persons who normally move around in the wheelchair independently. Independently
getting in / transferring is described accordingly. If an assistant is required, the steps described here should be
performed analogously with support:
1) Manoeuvre the wheelchairs so that they are positioned at an angle of approx. 45° degrees to each other (see
Fig. 6). Ensure that the brakes / wheel locks do not become entangled.
2) Engage the wheel locks of the wheelchair currently in use.
3) On the other wheelchair, engage the wheel locks and fold up the footrest (footplate) (see Fig. 7).
4) Move your feet from the footplate onto the floor and move forward in the wheelchair (see Fig. 8).
5) Make the transfer to the 2nd wheelchair (see Fig. 9). The method illustrated is one possible way to support
yourself.
NOTE Find the most suitable method for yourself by practising with the help of an assistant.
6) Finally fold the footplate down, place your feet on the footrest and release the wheel locks.
→ The wheelchair can now be used.

6.3 Information on use

6.3.1 Footrests

The user's feet can be placed on the footrest.
The height of the footrest has been adjusted by qualified personnel to the length of the user's lower leg.
The angle of the footplate has been set by the qualified personnel so that it allows the ankles to rest in a comfort­
able position.
14 | Ottobock
6
8
7
9
Ventus