Cleaning; Turning On The Machine - HAKO Scrubmaster B75R Operating Manual

3.4

Cleaning

No. Description
1 Turn on the machine
2 Select the driving direction via the driving direction selector switch
3 Select the cleaning programme
4 Loosen the parking brake and actuate the accelerator pedal. The
brushes and water supply are switched on.
5 Adjust the fresh water quantity as required using the adjusting lever of
the fresh water metering system.
Attention
2
3.4.1

Turning on the machine

Attention
• Before operating the machine, read and observe the safety
instructions in chapter 1.
• The machine can only be put into service when the driver is sitting
on the driver's seat.
• The travel drive can only be started when the accelerator pedal is
not actuated when turning the machine on.
1. Disconnect the mains plug from the socket and place it in the storage
recess.
2. Turn the machine on with the key switch.
3. Release the parking brake.
4. Select the driving direction with the driving direction selector switch.
5. Actuate the accelerator pedal.
03-7175-00-00.fm
Make sure that the adjusting lever has been opened
1
sufficiently. Water supply only starts from mark (1)
onwards!
0
•Position 0: Water supply OFF
•Position 1: Water supply MINIMUM
•Position 2: Water supply MAXIMUM
Putting into service
35